Gnar Bite — 6 inch Motor Hub Decal

Give your motor hub some teeth.

⚠️ IMPORTANT — ONE-SIDED APPLICATION

The Gnar Bite is designed for the flat, wire-side of the hub only.

The opposite side of the hub is too deeply concave for proper application. Do not purchase two expecting to install one on each side. One Gnar Bite is intended for one hub, on the flat wire-side surface.

Designed for riders who actually use their boards, the Gnar Bite adds an aggressive finishing touch without looking like an ordinary sticker slapped onto a board.

Made for real riding, grinding, and abuse, the Gnar Bite is designed with a permanent-style adhesive and decal construction that helps it tear or wear away in sections when damaged rather than lifting and peeling off from the point of impact. Your hub may get scratched, scraped, and beat up—the Gnar Bite is made to wear with it.

Details

• Custom shark-tooth design
• Sized specifically for 6-inch motor hubs
• Designed for the flat, wire-side of the hub
• Permanent-style adhesive
• One decal per order

Installation

1. Clean the hub: Thoroughly clean the flat wire-side surface. Remove all dirt, grease, and residue, then allow it to dry completely.
2. Position the decal: The Gnar Bite comes with a transparent transfer-tape film over the top. Carefully position the decal where you want it on the hub.
3. Apply: Press the decal firmly onto the hub, working across the entire design to ensure good adhesion.
4. Remove the transfer tape: Slowly peel the transparent transfer-tape film away from the decal. The shark-tooth decal should remain adhered to the hub.
5. Press and finish: Give the decal another firm press around the edges and across the design.

The transparent transfer tape is only used to apply the decal and should be removed after installation.

Gnar Park is not affiliated with or endorsed by any motor or board manufacturer.